Beside a freestanding stove, the wall board should follow a solution specified for the device. This also applies to a small apartment, where every piece of surface matters. Start with the stove instructions and wall cross-section before adjusting the sheet to free space.
Consider both sides of the corner
Check the required clearances, door opening path, and access to connections. Record materials hidden under the finishing of both walls. The same paint on the surface does not mean identical substrate on each side of the stove.
HT Fireboard is a heat-resistant board with described protective and finishing applications. Its properties do not independently determine the distances from all adjacent materials. The cover must meet the full requirements of the specific device.
Prepare the substrate and test fit
Check the stability and flatness of the installation area. Mark edges, joints, and necessary access on the drawing. A narrow section near the corner requires designated support; a straight decorative line does not replace proper fastening.
HB60 has applications in compatible temperature-resistant joints. Select it according to the board, wall, and solution instructions. The adhesive should bond the prepared materials and not randomly cover loose remnants of the old coating.
Maintain the finish within the described scope
Heat Resistant Plaster can be applied on a properly prepared HT board. Check the specified face of the sheet, priming, and layer. Take into account bonding, drying, and preparation of materials before normal use of the stove.
Keep photographs of the fixing and data of the applied layers. When replacing the stove, return to assessing the environment, even if the new model occupies a similar area. Documented protection makes comparison easier, but its prior installation does not automatically confirm the working conditions of each subsequent device.
